Finalized the last of the coolant hoses today. Now to fill the system and pressure test it for leaks.
I also replaced the three Weatherpack connectors going to the stop/tail lights on the rear clamshell with an eight pin Deutsch connector. Much better…
Search found 381 matches
- Mon May 06, 2024 8:37 pm
- Forum: Cobra stuff
- Topic: Mike's GT40 gets redone
- Replies: 119
- Views: 258794
- Fri May 03, 2024 9:08 pm
- Forum: Cobra stuff
- Topic: Fun thread on Club Cobra
- Replies: 1
- Views: 3965
Re: Fun thread on Club Cobra
I like the one at the pearly gates…
- Fri May 03, 2024 8:34 pm
- Forum: Not Cobra stuff
- Topic: Bot attacks
- Replies: 1
- Views: 963
Re: Bot attacks
Wow, I had no idea the bots were/are so prevalent…
- Wed May 01, 2024 10:28 pm
- Forum: Cobra stuff
- Topic: Mike's GT40 gets redone
- Replies: 119
- Views: 258794
Re: Mike's GT40 gets redone
Waiting on some parts to complete the coolant hose install. While waiting, I didn’t like the two -10 remote oil filter hoses I made with 45 degree fittings, so I remade them with 90 degree fittings. Much nicer install now, and should allow a cleaner routing for the coolant hoses. I reshaped the dips...
- Sun Apr 28, 2024 7:26 pm
- Forum: Cobra stuff
- Topic: Mike's GT40 gets redone
- Replies: 119
- Views: 258794
Re: Mike's GT40 gets redone
It’s just an open end wrench with no handle, just a square drive, good for getting into tight areas where a regular wrench won’t work.
- Sat Apr 27, 2024 8:55 pm
- Forum: Not Cobra stuff
- Topic: Drone Tech vs F1
- Replies: 1
- Views: 6614
- Sat Apr 27, 2024 8:29 pm
- Forum: Cobra stuff
- Topic: Mike's GT40 gets redone
- Replies: 119
- Views: 258794
Re: Mike's GT40 gets redone
Agree that they’re rarely used, but very necessary, as in this case, where nothing else will work…
- Fri Apr 26, 2024 8:26 pm
- Forum: Cobra stuff
- Topic: Mike's GT40 gets redone
- Replies: 119
- Views: 258794
Re: Mike's GT40 gets redone
Ha ha, functional art maybe…
- Fri Apr 26, 2024 5:51 pm
- Forum: Cobra stuff
- Topic: Mike's GT40 gets redone
- Replies: 119
- Views: 258794
Re: Mike's GT40 gets redone
Today I reinstalled the rear sway bar, and made new -10 hoses to connect the oil filter sandwich adapter to the chassis bulkhead fittings going to the remote oil filters. I didn’t have a 1” crowfoot, so I had to modify a 7/8” crowfoot to tighten the fittings. I also started mocking up the dipstick, ...
- Thu Apr 25, 2024 8:40 pm
- Forum: Cobra stuff
- Topic: Mike's GT40 gets redone
- Replies: 119
- Views: 258794
Re: Mike's GT40 gets redone
Making good progress. I have most of the electrical system reconnected. Torqued all of the motor/trans hardware. Reconnected the shifter brackets/cables and the hydraulic clutch hose. Refit the AC compressor brackets, and realigned the pulleys with shim washers. Had to make a few trips to O’Reilly’s...